Professional sharing splicing screen, daily maintenance knowledge
The application of LCD splicing screen (y. Ng y o ng) (extensive), more and more widely in our daily life can often see its shadow; although the performance of the LCD splicing screen (x ng n ng) (Interpretation: stable solid stability; no change), with long service life (lifetime) up to 100 thousand hours in support of 7 * 24 hours of continuous work (g only ng Zu o), but still maintain mosaic screen maintenance (Maintain) is still very important, then as a senior enterprise LCD splicing screen (Q from y) this is an introduction of liquid crystal (Introduction) the need to pay attention to the daily maintenance of stitching in maintenance knowledge and analysis of splicing screen problem.
About the daily maintenance maintenance (Maintain), first in the process of using splicing screen (Gu o ch ng) should pay attention to ensure the clean degree of use environment, to minimize dust, oil, into the big screen, the screen can also use special cleaning fluid, regular cleaning of the screen, in order to ensure its bright color, image clear. There are two kinds of splicing screen, one is the traditional large screen display wall hard splicing technology, and the other is the use of edge fusion technology seamless seamless projector technology. Place temperature should always pay attention to, it is recommended that the temperature between 25 degrees and 26 degrees, you can install air-conditioning in the place, fully guarantee the use of liquid crystal mosaic screen temperature environment.
If it is found that liquid crystal splicing screen surface dirt (g o u) (soil) (SH y, should be used from which accurate method (f ng) a ng f million) to remove the dirt. The use of medium (decisive material) is the best soft, non fiber material, such as cotton, lens paper or soft cloth, and then with a little glass cleaner gently wipe, chemical solution to prohibit the use of alcohol kind, also cannot use coarse (coarse) cloth or paper items, because this kind of material is easy to produce scratches. Here to remind you, don't be cleaner spray directly to the surface of the screen appears, it is very easy to flow to the screen LCD (using the same skill or item time interval) screen internal short-circuit (current not by the use of electrical appliances, directly connected to the mains poles) fault (fault), resulting in unnecessary the loss (loss).
The LCD screen for a long time work (g only ng Zu o) very easily make some pixels overheating, once more than limit will cause permanent damage (cause), which formed the dead often say. DID can according to customer requirements for the application of LCD screen system and the size of the system, according to the actual application environment, select appropriate splicing method and the best products, personalized design, to meet customer demand. Since the pixels of the liquid crystal mosaic screen are made of liquid crystals, when the continuous (Continuity) load is more than 96 hours at work, it will accelerate its aging, and even burn out in severe cases. So, if the user must work for a long time, can make the best of intermittent rest, or often in different time intervals (Ji, N, g) to change the screen display content, because in a wait state (Zhu, ng T, I) to reduce the brightness, or the screen saver mode (m SH). Under the operation for a while, this effort can not only delay the aging LCD screen, and can prevent the damage of hardware.
The DID series of LCD splicing products (CH million N P from n (core)) as the core, and strive to do fine, do, including DID 40, 46, 55 LCD, 60, 70, 82 the size of the narrow side series, ultra narrow series, can meet the full range of customers need. Touch touch machine using infrared touch screen is the use of X, Y direction of the infrared matrix densely located to detect and locate the user's touch.
